Bot Skins

Wrapping a service robot in your brand colours

A printed vinyl wrap changes a robot's whole appearance without paint. It is the most permanent way to dress one, so a little planning before anything goes to print saves a lot of trouble later.

  • Design files
  • Panels
  • Fitting
  • Removal
Illustration of a service robot wrapped in diagonal coral stripes, with the head, sensor window and stop button left unwrapped

Getting the artwork right

Start from the robot, not the logo

Measure each panel you plan to cover and photograph the robot from the front, back and both sides. Wraps are usually designed panel by panel, so the printer needs the outline of every section, plus the position of anything that must stay bare.

Supply files a printer can use

Logos and lettering should be vector artwork so they stay crisp at any size. Photos need enough resolution for the size they'll be printed. Give exact brand colour references and ask for a printed proof, because colour on a monitor and colour on vinyl rarely match perfectly.

Keep key elements away from edges

Text and logos near a panel join or a tight curve can be cut, stretched or hidden. Place them on the flattest, most visible areas and leave a margin around seams.

Mark the cut-outs

Show every sensor window, camera, speaker, vent, stop button, charging contact, screw and service hatch on the template. The installer trims around each one, so the design should expect gaps there.

Panel shapes and what they mean

The shape of the shell decides where a wrap works well.

Flat panels

The easiest to wrap and the best home for logos and text.

Gentle curves

Wrap well with a conformable film applied with some heat.

Tight curves and recesses

Prone to lifting. Often better left bare or covered in a plain colour.

Removable panels

Wrapped separately, so service access still works and seams stay tidy.

Applying and removing a wrap

Material choice

Cast vinyl is generally more conformable than calendered vinyl and copes better with curves. A clear laminate over the print adds resistance to scuffs and repeated cleaning. Films with removable adhesive make life easier if the robot is leased or may be sold on.

Fitting

The shell must be properly clean first, as hand oils, cleaning residue and dust all weaken the bond. Installers typically use a surface cleaner suited to plastic, let it dry fully, and work somewhere sheltered and dust-free.

Film is laid on, squeegeed out from the centre and warmed to help it follow curves. Edges are trimmed carefully around cut-outs, and a blade must never score the shell or nick a sensor window. Because that trimming is fiddly, many businesses use an experienced wrap installer.

Afterwards, run the robot through its whole routine, including docking, before it returns to service.

Removal

Warm the film to soften the adhesive, then peel slowly at a low angle. Pulling fast or cold tends to leave adhesive behind or lift the shell's finish. Remove any residue with a product that is safe for the plastic, testing it on a hidden spot first.

How long a wrap lasts

Lifespan depends more on handling than on time.

Film grade, laminate, cleaning habits and how often the robot gets bumped all affect how long a wrap looks good. Indoor robots avoid sun and weather, which helps, but harsh chemicals, abrasive pads and constant knocks at edges wear it down. Ask the printer for the rated life of the film they propose and the cleaning products they recommend.

Expect the most exposed panels, usually the lower ones, to need patching or replacing before the rest.

Check with the robot's manufacturer or supplier before wrapping, in case adhesives on the shell affect the warranty.

If a full wrap is more than you need, our sister guide to decals, tray signs and name plates covers lighter options.

Considering a service robot for your business? General information is at robotx.au.